Firstly everyone forgive me regarding how long its been since I have updated this blog or added content to my Shapeways shop. I'm presently planning my wedding for December of this year. It's a fantastic and happy occasion but it leaves little time for modeling or other projects. I appreciate all the email requests and best wishes I've gotten as well as everyone's patience.
The main reason for this post however is that it has come to my attention that Shapeway's hasn't been able to send correspondence to one of my email accounts for approximately two to three months. This means I haven't gotten failure to print notices for objects ordered for that entire time. If people have anything they have ordered that failed send me an email or private massage and I'll try to fix it.
In case people wonder, failures are happening because Shapeways has been adjusting the print rules for Frosted Detail and Frosted Ultra Detail to insure better print ability. In the long run the new print restrictions will eventually lead to more consistent and successful print of higher quality in FD/FUD. In the short run the results basically mean that thin wires now have a minimum of .8mm to print better at 1mm (same as WSF). Since most of my wires have been made at .75 its just bellow print-ability and for safety some heavy beefing up is needed.
I'm slowly fixing things as I get time. with 650 products this will take a while. My priority for repairs is things that have failed on ordering.
Please bare with me.
present errors I know of.
Claptrap (claptrap's antennae)
Protoss (energy blades failed)
Halo Pistol (trigger guard)
Advanced Sonic Rifle (presumably all sonic weapons as its the dish that caused the error)
Shapeways is getting me a further list of the messages I missed but I'll get on these ASAP.
No comments:
Post a Comment